Fireplace Glass Installation - Fireplace & Fire Pit
These
instructions are assuming you already have a gas line going to your
fireplace. If you do not have a gas line running to your fireplace call
your local plumber or heating and cooling company to get one installed.
You will also need a shut-off valve installed in the gas line feeding
your fireplace.
Step 1: Lay a drop cloth on the floor and clean the walls of your
fireplace. A wire brush may be used if needed to remove any soot build
up from the firebrick. Wipe the surfaces clean with a dry cloth to
remove any dust. Be careful of soot, it can and will ruin carpeting,
wall paper, paint, clothes, furniture, and anything else it comes into
contact with. If you are painting the inside of the fireplace (this
makes for a very nice finish) mask off the areas you don’t want any
paint on with tape. Spray your paint and remove the masking once dry.
Step 2:
Connect the burner to your gas line with a flexible connector. The
holes in the burner should be facing up. Light the burner to check that
you have the flame pattern in the center of the fireplace and that the
flames are going up. If not properly placed you may get flames lapping
on the back fireplace wall or being pulled back due to the draft. This
will cause soot to build up and will not look good. Now you have found
the general location for the burner.
Step 3:
Note: skip this step if you are using the 3" fill method:
Starting about 3"-4" back from the front of the fireplace pour in about
a 2" bed of crushed lava rock. Pull the burner to the top and light it
again to insure the pattern has not changed. Now cover the holes in the
burner with tape to keep sand from getting into the burner. Spread sand
over the burner and lava rock until there is a semi flat even surface
(the top of the burner should just barely stick up above the sand).
Brush off the burner, remove the tape, and light it again checking for
the flame pattern once more. If you are satisfied with the look you can
move onto the next step, if you are not you may try readjusting the
placement of the burner.
Step 4:
Now you're ready to add the glass. Start from the front and move
towards the back. You will end up with about a 3" layer of glass (with
no lava rock or sand under it) in the front of the fireplace and about a
1" layer of glass (with lava rock and sand under it) in the back. By
tapering the front slightly you will help keep the glass in the
fireplace. We recommend you add the glass slowly as it looks better if
you take your time. We also have found that if you do this at nighttime
it makes more sense as you can see the actual effects of the fire and
the toppings. This completes the installation of your fireplace glass.
Fire Pit
Installation:
First
be sure that your firepit contains drains for elimination of rain water
inside the pit. Four (4) 1” holes in the bottom of the pit should be
sufficient to drain rain water.
For a fire
pit installation you can follow the same basic steps as in the 2" method
fireplace installation above. The only basic difference is the amount
of, and type of filler you use to fill the majority of your fire pit.
If your fire pit is very large and originally built for wood burning you
will want to use a product such as pea gravel, washed rock or lava rock
whatever is available in your area as "filler". Be sure you use
something that is not combustible and will not break down over time or
your glass could sink into the fire pit base.
|
